Home › Engine / Hybrid System › 1NZ-FE COOLING › COOLING FAN RESISTOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017081 1NZ-FE COOLING _0090206 COOLING FAN RESISTOR A

1NZ-FE COOLING  COOLING FAN RESISTOR  INSTALLATION  


PROCEDURE

Hide 85928B 1.INSTALL COOLING FAN RESISTOR

a.

Install the cooling fan resistor to the front side member reinforcement sub-assembly with the 2 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


b.

Connect the cooling fan resistor connector.


Hide 53876A 2.CONNECT FRONT FENDER LINER LH

a.

Connect the front side of front fender liner LH to the front bumper cover and front fender apron sub-assembly with the 3 screws and 3 clips.


Hide 3.INSTALL FRONT WHEEL LH

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)