Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTER › 2013.08–2016.07
RM30M0E _51 Engine / Hybrid System _017085 1NZ-FE STARTING _0090212 STARTER A

1NZ-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly and oil pan sub-assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the terminal 50 connector.


c.

Connect the terminal 30 to the magnet starter switch assembly with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Close the terminal cap.


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A305624

Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block sub-assembly and while pushing it along the cylinder block sub-assembly, fit the claw into the cylinder block sub-assembly.

NOTICE:
·

Make sure that the claw makes a click sound, indicating that it fits tightly.

·

Replace the claw with a new one if it does not fit tightly or is deformed.




Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 4.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)