Home › Engine / Hybrid System › 1NZ-FE STARTING › IGNITION SWITCH › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017085 1NZ-FE STARTING _0090213 IGNITION SWITCH A

1NZ-FE STARTING  IGNITION SWITCH  REMOVAL  


PROCEDURE

Hide 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 69057A 2.REMOVE IGNITION SWITCH LOCK CYLINDER AND KEY SET

Hide 84450 3.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY

A250060

a.

Disengage the 2 claws to remove the ignition or starter switch assembly from the ignition switch lock cylinder and key set.

NOTICE:
·

Perform this operation after situating the ignition switch lock cylinder and key set in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.

·

Do not turn the ignition switch lock cylinder and key set sideways or downward because doing so might release the ignition switch lock cylinder and key set's component parts.