Home › Engine / Hybrid System › 1NZ-FE STARTING › RELAY › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017085 1NZ-FE STARTING _0090214 RELAY G

1NZ-FE STARTING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 28300 1.INSPECT STARTER RELAY ASSEMBLY

E209082

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the starter relay assembly.