Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM › 2013.08–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090604 AUTOMATIC TRANSAXLE SYSTEM D

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  INITIALIZATION  


RESET MEMORY


NOTICE:
·

Perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

·

The Reset Memory can only be performed using a GTS.



HINT:

The ECM store the conditions that the ECT controls the automatic transaxle assembly and engine assembly in accordance with those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM is replaced, it is necessary to reset the memory so that the ECM can store the new information.

The reset procedure is as follows.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menu: Powertrain / Engine and ECT / Utility / Reset Memory.

Powertrain > Engine and ECT > Utility
Tester Display
Reset Memory
50005 234 176
NOTICE:

After performing the Reset Memory, be sure to perform the Road Test as described earlier.

Click hereDrivetrain>U340E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>ROAD TEST


HINT:

The ECM stores learned values by performing the Road Test.