Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM › 2013.08–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090604 AUTOMATIC TRANSAXLE SYSTEM D

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data that were recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display both current and pending DTCs.

·

Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.



CHECK FOR DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Using GTS)


a.

Connect GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Clear DTCs
50002 234

e.

Clear the DTCs.



CLEAR DTC (Without GTS)


a.

Perform either of the following operations:

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI NO. 3 fuse from the driver side junction block assembly (located inside the instrument panel) and the ETCS fuse from the engine room relay block (located inside the engine compartment) for more than 1 minute.