The shift solenoid valve SLT controls the transmission line pressure for smooth transmission operation based on signals from the throttle position sensor and vehicle speed sensor. The ECM adjusts the shift solenoid valve SLT to control hydraulic line pressure coming from the primary regulator valve. Appropriate line pressure assures smooth shifting with varying engine outputs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2716 | Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) | Open or short is detected in shift solenoid valve SLT circuit for 1 second or more while driving (1-trip detecting logic). | ·
Wire harness or connector ·
Transmission wire ·
Shift solenoid valve SLT ·
ECM |
Comes on | DTC stored |
When an open or short in the linear solenoid valve (SLT) circuit is detected, the ECM interprets this as a fault. The ECM turn on the MIL and stores the DTC.
| *a | Component without harness connected
(Transmission Wire) |
Disconnect the B20 transmission wire connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (SLT+) - 8 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 3 (SLT+) - Body ground | Always | 10 kΩ or higher |
| 8 (SLT-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Rear view of wire harness connector
(to ECM) |
Connect the B20 transmission wire connector to the transaxle.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B31-12 (SLT+) - B31-13 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| B31-12 (SLT+) - Body ground | Always | 10 kΩ or higher |
| B31-13 (SLT-) - Body ground | Always |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Shift Solenoid Valve SLT) |
Remove the shift solenoid valve SLT.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
The solenoid makes operating sounds.
| Proceed to |
|---|
| OK |
| NG |
OK
NG