Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE › 2013.08–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090607 TRANSMISSION WIRE G

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSPECTION  


PROCEDURE

Hide 82125J 1.INSPECT ATF TEMPERATURE SENSOR (TRANSMISSION WIRE)

a.

Check the resistance.

i.
C229166C07
2.302,0.979 2.677,0.729 true 2.313,1.26 2.688,1.469 true 0.146,0.146 0.458,0.302 0.313,0.156 10 false *a 2.729,0.615 3.125,0.833 0.396,0.219 10 false THO 2.74,1.375 3.135,1.594 0.396,0.219 10 false E2
*a Component without harness connected
(ATF Temperature Sensor (Transmission Wire))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THO) - 6 (E2) Always 79 Ω to 156 kΩ
1 (THO) - Body ground Always 10 kΩ or higher
6 (E2) - Body ground Always 10 kΩ or higher


HINT:

If the resistance is outside the specified range at either of the ATF temperatures shown in the table below, the driveability of the vehicle may be affected.


Standard Resistance:
ATF Temperature Specified Condition
10°C (50°F) 5 to 8 kΩ
25°C (77°F) 2.5 to 4.5 kΩ
110°C (230°F) 0.22 to 0.28 kΩ


If the result is not as specified, replace the ATF temperature sensor (transmission wire).