Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH › 2013.08–2014.03
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090609 PARK / NEUTRAL POSITION SWITCH A

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 51442C 2.REMOVE ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51451A 3.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 33820B 5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the automatic transaxle assembly side.


a.

Apply the parking brake and move the shift lever to N.


b.
C286312

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C282050

Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.


d.

Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 84540 6.REMOVE PARK/NEUTRAL POSITION SWITCH

a.
C282394

Disconnect the connector from the park/neutral position switch.


b.
C282395

Remove the nut, washer and transmission control shaft lever from the automatic transaxle assembly.


c.
C117104

Using a screwdriver, pry off the tabs of the lock plate.


d.

Remove the lock nut and lock plate from the park/neutral position switch.


e.
C117106

Remove the 2 bolts and pull out the park/neutral position switch from the automatic transaxle assembly.