58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY
51442C
2.REMOVE ENGINE UNDER COVER LH (w/o Metal Type Under Cover)
51451A
3.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
51405A
4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
57533B
5.REMOVE FRONT FLOOR CENTER BRACE
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58151
7.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.
33820B
8.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the automatic transaxle assembly side.
Apply the parking brake and move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Nut |
|
Rotate approximately 180° |
|
Pull out |
Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
Separate the transmission control cable assembly from the transmission control cable support.
Remove the 3 nuts and transmission control cable assembly from the body.
33829
9.REMOVE NO. 1 TRANSMISSION CONTROL CABLE SUPPORT
Perform this procedure only when replacement of the No. 1 transmission control cable support is necessary.
Remove the nut and No. 1 transmission control cable support from the body.