35617
1.INSTALL CLUTCH DRUM OIL SEAL RING
Coat 2 new clutch drum oil seal rings with Toyota Genuine ATF WS, and install them to the stator shaft assembly.
35301A
2.INSTALL FRONT OIL PUMP OIL SEAL
Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body.
-0.2 to 0.2 mm (-0.00787 to 0.00787 in.)
Coat the lip of the front oil pump oil seal with MP grease.
35322
3.INSTALL FRONT OIL PUMP DRIVEN GEAR
| *a | Mark |
Coat the front oil pump driven gear with Toyota Genuine ATF WS, and install it to the front oil pump body with the marked side facing upward.
35321
4.INSTALL FRONT OIL PUMP DRIVE GEAR
| *a | Mark |
Coat the front oil pump drive gear with Toyota Genuine ATF WS, and install it to the front oil pump body with the marked side facing upward.
35370
5.INSTALL STATOR SHAFT ASSEMBLY
Using a T30 "TORX" socket wrench, install the stator shaft assembly to the front oil pump body with the 10 bolts.
6.INSPECT OIL PUMP ASSEMBLY
Turn the front oil pump drive gear with 2 screwdrivers and make sure it rotates smoothly.
Do not damage the lip of the front oil pump oil seal.
35301B
7.INSTALL FRONT OIL PUMP BODY O-RING
Coat a new front oil pump body O-ring with Toyota Genuine ATF WS, and install it to the front oil pump body.