Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › 2013.08–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090617 DIFFERENTIAL CASE G

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

a.
C282885

Using a dial indicator, measure the front differential side gear backlash while holding one of the front differential pinions toward the front differential case.

Standard backlash:

0.05 to 0.20 mm (0.00197 to 0.00787 in.)


If the backlash is not as specified, replace the front differential side gear thrust washers.

Thrust Washer Thickness:
Part No. Thickness
mm (in.)
41361-17010 0.95 (0.0374)
41361-17020 1.00 (0.0394)
41361-17030 1.05 (0.0413)
41361-17040 1.10 (0.0433)
41361-17050 1.15 (0.0453)
41361-17060 1.20 (0.0472)


HINT:
·

Measure the thickness with a micrometer to select a proper thrust washer because the thrust washers do not have any distinguishing marks.

·

Select thrust washers of the same thickness for both the right and left sides.