41311E
1.REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case front tapered roller bearing inner race from the front differential case.
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case front tapered roller bearing outer race from the transaxle housing.
33481X
2.REMOVE SPEEDOMETER DRIVE GEAR
Remove the speedometer drive gear from the front differential case.
41311F
3.REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case rear tapered roller bearing inner race from the front differential case.
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case rear tapered roller bearing outer race and the front differential case rear shim from the transaxle case.
41221
4.REMOVE FRONT DIFFERENTIAL RING GEAR
| *a | Matchmark |
Place matchmarks on the front differential ring gear and the front differential case.
Using SST and a hammer, release the 4 front differential ring gear set bolt lock plates.
Secure the front differential case in a vise between aluminum plates.
Do not overtighten the vise.
Remove the 8 bolts and the 4 front differential ring gear set bolt lock plates.
Using a plastic hammer, remove the front differential ring gear from the front differential case.
41342A
5.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a punch and a hammer, release the staked part of the front differential case hole.
Using a 5 mm pin punch and a hammer, remove the front differential pinion shaft straight pin from the front differential case.
41342F
6.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the front differential case.
41039A
7.REMOVE DIFFERENTIAL GEAR KIT
Remove the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers from the front differential case.
Rotating each front differential side gear, remove the 2 front differential pinions and the 2 front differential pinion thrust washers.