Home › Drivetrain › U441E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM › 2013.08–2016.10
RM30M0E _52 Drivetrain _017088 U441E AUTOMATIC TRANSMISSION / TRANSAXLE _0090618 AUTOMATIC TRANSAXLE SYSTEM D

U441E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic.



CHECK MODE PROCEDURE


HINT:

GTS only: Compared to normal mode, check mode is more sensitive for detecting malfunctions. Furthermore, the same diagnostic items which are detected in normal mode can also be detected in check mode.


a.

Procedure for check mode using the GTS.

i.

Check the initial conditions.

·

Battery voltage 11 V or more.

·

Throttle valve fully closed.

·

Shift lever is in P or N.

·

A/C off.



ii.

Turn the ignition switch off.


iii.

Connect the GTS to the DLC3.


iv.

Turn the ignition switch to ON.


v.

Turn the GTS on.


vi.
A296535E04
1.927,1.802 3.073,2.052 1.146,0.25 10 false 0.13 seconds 0.125,0.76 0.438,0.958 0.313,0.198 10 false ON 0.125,1.521 0.531,1.719 0.406,0.198 10 false OFF 2.01,0.427 2.865,0.635 0.854,0.208 10 false 0.13 seconds

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode (Check that the MIL flashes as shown in the illustration).

Powertrain > Engine and ECT > Utility
Tester Display
Check Mode
50005 234 1
NOTICE:

All DTCs and freeze frame data recorded are erased if: 1) the GTS is used to change the ECM from normal mode to check mode or vice-versa; or 2) during check mode, the ignition switch is turned from ON to ACC or off.



vii.

Start the engine (the MIL goes off after the engine starts).


viii.

Perform Monitor Drive Pattern for the ECT test, or simulate the conditions of the malfunction described by the customer.

Click hereDrivetrain>U441E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>MONITOR DRIVE PATTERN

NOTICE:

Leave the ignition switch ON until you have checked the DTCs.



ix.

After simulating malfunction conditions, use the GTS to check the DTCs and freeze frame data.