41311E
1.REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case front tapered roller bearing (inner race) from the front differential case.
Apply a small amount of grease to the threads of SST before use.
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case front tapered roller bearing (outer race) from the transaxle housing.
Apply a small amount of grease to the threads of SST before use.
41311F
2.REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case rear tapered roller bearing (inner race) from the front differential case.
Apply a small amount of grease to the threads of SST before use.
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case rear tapered roller bearing (outer race) and the front differential case rear plate washer from the transaxle case.
Apply a small amount of grease to the threads of SST before use.
41221
3.REMOVE FRONT DIFFERENTIAL RING GEAR
| *a | Matchmark |
Place matchmarks on the front differential ring gear and the front differential case.
Secure the front differential case in a vise between aluminum plates.
Do not overtighten the vise.
Remove the 8 bolts.
Using a plastic hammer, remove the front differential ring gear from the front differential case.
41342A
4.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a punch and a hammer, release the staked part of the front differential case hole.
Using a 3 mm pin punch and a hammer, remove the front differential pinion shaft straight pin from the front differential case.
41342F
5.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the front differential case.
41039A
6.REMOVE DIFFERENTIAL GEAR KIT
Remove the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers from the front differential case.
Rotating each front differential side gear, remove the 2 front differential pinions and the 2 front differential pinion thrust washers.