IMMOBILISER SYSTEM DESCRIPTION
The immobiliser system is designed to prevent the vehicle from being stolen. This system uses the transponder key ECU assembly that stores the key ID codes of authorized ignition keys. If an attempt is made to start the engine using an unauthorized key, the transponder key ECU assembly sends a signal to the ECM to prohibit fuel delivery and ignition, effectively disabling the engine.
FUNCTION OF MAIN COMPONENTS
| Component | Outline |
|---|---|
| Transponder key ECU assembly | When the key is inserted into the ignition key cylinder, and the ignition switch is turned on, the transponder key amplifier coil receives the key code. Then the transponder key amplifier coil amplifies the ID code and outputs it to the transponder key ECU assembly.
Checks the ID code received from the key and if the results match, an EFI operation permission signal is sent through SFI communication. |
| ECM | The ECM receives key ID code verification results from the transponder key ECU assembly. The ECM also verifies the ECUs. Then judgment of whether to immobilise the engine is made. |
SYSTEM FUNCTION
When the transponder key ECU assembly detects that the key is in the ignition key cylinder, and the ignition switch is turned on, the transponder key ECU assembly provides current to the transponder key amplifier coil and produces a weak electric wave. A transponder chip in the key grip receives the electric wave. Upon receiving the electric wave, the transponder chip outputs a key ID code signal. The transponder key amplifier coil receives this signal, the signal is amplified by the transponder key amplifier built into the transponder key ECU assembly and the signal is transmitted to the transponder key ECU assembly.
The transponder key ECU assembly compares the key ID code with the vehicle ID code, which was previously registered in the transponder key ECU assembly, and communicates the results to the ECM. After the identification results show that the key ID code matches the vehicle ID code and the transponder key ECU assembly has confirmed their match, the engine immobiliser system is canceled and engine starting controls (fuel injection control and ignition control) enter standby mode.