Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › CYLINDER HEAD › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017073 1NZ-FE ENGINE MECHANICAL _0091008 CYLINDER HEAD A

1NZ-FE ENGINE MECHANICAL  CYLINDER HEAD  DISASSEMBLY  


PROCEDURE

Hide 11117A 1.REMOVE NO. 1 HEAD TAPER SCREW PLUG

a.
A302804

Using a 10 mm socket hexagon wrench, remove the No. 1 head taper screw plug and gasket.


Hide 13751 2.REMOVE VALVE LIFTER

a.

Remove the valve lifters.

HINT:

Keep the removed parts in the correct order so that they can be returned to their original locations when reassembled.



Hide 11117B 3.REMOVE NO. 2 HEAD TAPER SCREW PLUG

a.
A301972C01
1.552,1.906 1.167,2.063 true 1,1.969 1.313,2.125 0.313,0.156 10 false *a
*a 8 mm Socket Hexagon Wrench


Using an 8 mm socket hexagon wrench, remove the No. 2 head taper screw plug and gasket.


Hide 15678A 4.REMOVE OIL CONTROL VALVE FILTER

A302805

a.

Remove the oil control valve filter.


Hide 13711 5.REMOVE INTAKE VALVE

a.
A301969E01
1.604,0.75 1.25,0.333 true 0.927,0.26 1.385,0.458 0.458,0.198 10 false SST

Using SST, compress and remove the 2 retainer locks.

SST
09202-70020  (09202-00010)

HINT:

Keep the removed parts in the correct order so that they can be returned to their original locations when reassembled.



b.

Remove the retainer, valve spring and intake valve.

HINT:

Keep the removed parts in the correct order so that they can be returned to their original locations when reassembled.



Hide 13715 6.REMOVE EXHAUST VALVE

a.

Using SST, compress and remove the 2 retainer locks.

SST
09202-70020  (09202-00010)

HINT:

Keep the removed parts in the correct order so that they can be returned to their original locations when reassembled.



b.

Remove the retainer, valve spring and exhaust valve.

HINT:

Keep the removed parts in the correct order so that they can be returned to their original locations when reassembled.



Hide 7.REMOVE VALVE STEM OIL SEAL

a.
A301987

Using needle-nose pliers, remove the valve stem oil seals.


Hide 13734 8.REMOVE VALVE SPRING SEAT

a.
A301988

Using compressed air and magnet hand, remove the valve spring seats by blowing air onto them.

NOTICE:

Do not splash engine oil with the compressed air.



Hide 9.REMOVE STUD BOLT

a.

Using an E5 and E7 "TORX" socket wrench, remove the 7 stud bolts.


Hide 11151A 10.REMOVE CAMSHAFT BEARING CAP SETTING RING PIN

a.

Remove the 2 camshaft bearing cap setting ring pins.