Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › CYLINDER HEAD › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017073 1NZ-FE ENGINE MECHANICAL _0091008 CYLINDER HEAD A

1NZ-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 13711 1.REPAIR INTAKE VALVE

A282572E02
1.646,1.677 1.75,1.698 0.104,0.021 2.156,0.406 2.469,0.583 0.313,0.177 10 false 45° 2.281,0.698 2.594,0.875 0.313,0.177 10 false 20° 0.969,1.688 2,2.031 1.031,0.344 10 true 1.0 to 1.4 mm (0.04 to 0.06 in.) 1.927,0 2.24,0.177 0.313,0.177 10 false 75°

a.

Repair the intake valve seat.

NOTICE:

Releasing the seat-cutter pressure gradually helps to the make valve seat face smoother.



b.

If the seating is too high on the valve face, use 20° and 45° cutters to correct it.


c.

If the seating is too low on the valve face, use 75° and 45° cutters to correct it.


d.

Hand-lap the valve and valve seat with an abrasive compound.


e.

Recheck the valve seating position.


Hide 13715 2.REPAIR EXHAUST VALVE

A282574E02
1.646,1.646 1.75,1.667 0.104,0.021 2.167,0.375 2.479,0.552 0.313,0.177 10 false 45° 2.281,0.667 2.594,0.844 0.313,0.177 10 false 20° 0.844,1.667 1.875,2.01 1.031,0.344 10 true 1.0 to 1.4 mm (0.04 to 0.06 in.) 1.938,0 2.25,0.177 0.313,0.177 10 false 75°

a.

Repair the exhaust valve seat.

NOTICE:

Releasing the seat-cutter pressure gradually helps to the make valve seat face smoother.



b.

If the seating is too high on the valve face, use 20° and 45° cutters to correct it.


c.

If the seating is too low on the valve face, use 75° and 45° cutters to correct it.


d.

Hand-lap the valve and valve seat with an abrasive compound.


e.

Recheck the valve seating position.