Home › Drivetrain › CLUTCH › CLUTCH RELEASE CYLINDER
RM30M0E _52 Drivetrain _017089 CLUTCH _0091139 CLUTCH RELEASE CYLINDER A

CLUTCH  CLUTCH RELEASE CYLINDER  REASSEMBLY  


PROCEDURE

Hide 04313 1.INSTALL RELEASE CYLINDER PISTON

a.
C128485
0,0 3.427,0 false
V100135

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to a new release cylinder piston.


b.
C235147
0.438,0.917 0.438,0.688 false 1.115,1.188 1.115,0.958 false 1.854,1.521 1.854,1.188 false 2.656,1.927 2.656,1.698 false 0.375,0.917 0.688,1.073 0.313,0.156 10 false *1 1.063,1.198 1.375,1.354 0.313,0.156 10 false *2 1.802,1.521 2.115,1.677 0.313,0.156 10 false *3 2.604,1.927 2.917,2.083 0.313,0.156 10 false *4
*1 Compression Spring
*2 Release Cylinder Piston
*3 Release Cylinder Push Rod
*4 Release Cylinder Boot


Install a new compression spring and release cylinder piston to the release cylinder body.

NOTICE:

Do not damage the inside of the release cylinder body.


HINT:

Install the smaller end of the compression spring to the release cylinder piston.



c.

Install a new release cylinder boot to the release cylinder push rod.


d.

Install the release cylinder boot and release cylinder push rod to the release cylinder body.


Hide 31477 2.INSTALL RELEASE CYLINDER BLEEDER PLUG

a.

Install the release cylinder bleeder plug to the release cylinder body.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 31478 3.REMOVE RELEASE CYLINDER BLEEDER PLUG CAP

a.

Install the release cylinder bleeder plug cap to the release cylinder bleeder plug.