31250B
1.INSTALL CLUTCH DISC ASSEMBLY
| *1 | Clutch Disc Assembly |
| *2 | Flywheel Sub-assembly |
Insert SST into the clutch disc assembly, and then insert them both into the flywheel sub-assembly.
Insert the clutch disc assembly in the correct direction.
31210
2.INSTALL CLUTCH COVER ASSEMBLY
| *a | Matchmark |
| *b | Temporarily Tighten |
Align the matchmark on the clutch cover assembly with that on the flywheel sub-assembly.
Using SST, center the clutch disc assembly, and following the procedure shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin at the top.
Following the order in the illustration, tighten the bolts evenly one at a time.
Move SST up and down, right and left lightly after checking that the clutch disc assembly is in the center, and tighten the bolts.
31210
3.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.
0.5 mm (0.0197 in.)
If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
31236B
4.INSTALL RELEASE FORK SUPPORT
Using a 19 mm deep socket wrench, install the release fork support to the manual transaxle assembly.
31126
5.INSTALL CLUTCH RELEASE FORK BOOT
Install the clutch release fork boot to the manual transaxle assembly.
31232A
6.INSTALL RELEASE BEARING HUB CLIP
Install the release bearing hub clip to the clutch release bearing assembly.
31204
7.INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
|
Release Hub Grease |
Apply release hub grease to the contact surfaces of the clutch release fork sub-assembly and the clutch release bearing assembly, the clutch release fork sub-assembly and the release cylinder push rod, and the clutch release fork sub-assembly and the release fork support.
Toyota Genuine Release Hub Grease or equivalent
Engage the release bearing hub clip and install the clutch release fork sub-assembly to the clutch release bearing assembly.
31230
8.INSTALL CLUTCH RELEASE BEARING ASSEMBLY
Install the clutch release bearing assembly with the clutch release fork sub-assembly to the manual transaxle assembly.
Engage the clutch release fork sub-assembly to the release fork support.
After the installation, move the clutch release fork sub-assembly forward and backward to check that the clutch release bearing assembly slides smoothly.
|
Clutch Spline Grease |
Apply clutch spline grease to the input shaft spline.
Toyota Genuine Clutch Spline Grease or equivalent
30300
9.INSTALL MANUAL TRANSAXLE ASSEMBLY