1.INSPECT AND ADJUST CLUTCH PEDAL HEIGHT
Turn back the floor carpet.
Check that the pedal height is correct.
| *a | Pedal Height from Floor Panel | *b | Pedal Height Adjust Point |
|
Measuring Plane of Floor Panel | - | - |
145 to 155 mm (5.71 to 6.10 in.)
If the pedal height is not as specified, adjust it as follows.
Loosen the lock nut and turn the clutch pedal stopper bolt until the correct height is obtained.
Tighten the lock nut.
2.INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY
| *a | Push Rod Play and Free Play Adjust Point |
| *b | Push Rod Play |
| *c | Pedal Free Play |
Check that the pedal free play and push rod play are correct.
Pay close attention to the change in resistance to distinguish between pedal free play and push rod play while performing the inspection.
Depress the pedal until clutch resistance begins to be felt.
5.0 to 15.0 mm (0.197 to 0.590 in.)
Gently depress the pedal until resistance begins to increase a little.
1.0 to 5.0 mm (0.0394 to 0.196 in.)
If necessary, adjust the pedal free play and push rod play.
The push rod play can be adjusted by changing the length of the push rod. Pedal free play changes together with push rod play.
Loosen the lock nut and turn the push rod until the correct pedal free play and push rod play are obtained.
When loosening the lock nut, be sure to hold the clutch master cylinder push rod clevis in place by its square portion.
If pedal free play and push rod play are not within the standard range even after adjustment, inspect the related parts.
Tighten the lock nut.
When tightening the lock nut, be sure to hold the clutch master cylinder push rod clevis in place by its square portion.
After adjusting the pedal free play and push rod play, check the pedal height.
3.INSPECT CLUTCH RELEASE POINT
| *a | Release Point |
| *b | Full Stroke End Position |
| *c | from Pedal Stroke End Position to Release Point |
| *d | Pedal Stroke |
Check the release point.
Pull the parking brake lever and install wheel chocks.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears contact each other.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
25 mm (0.984 in.) or more (from pedal stroke end position to release point)
120 to 130 mm (4.73 to 5.11 in.)
If the distance is not as specified, perform the following procedure:
Check the pedal height.
Check the push rod play and pedal free play.
Bleed the clutch line.
Check the clutch cover and clutch disc.
Install the floor carpet.