1.INSPECT 4TH GEAR THRUST CLEARANCE
Using a feeler gauge, measure the 4th gear thrust clearance.
0.10 to 0.55 mm (0.00394 to 0.0216 in.)
0.55 mm (0.0216 in.)
If the clearance exceeds the maximum, replace the No. 2 transmission clutch hub, 4th gear or input shaft rear radial ball bearing.
2.INSPECT 3RD GEAR THRUST CLEARANCE
Using a dial indicator, measure the 3rd gear thrust clearance.
0.10 to 0.35 mm (0.00394 to 0.0137 in.)
0.35 mm (0.0137 in.)
If the clearance exceeds the maximum, replace the No. 2 transmission clutch hub, 3rd gear or input shaft.
3.INSPECT 4TH GEAR RADIAL CLEARANCE
Using a dial indicator, measure the 4th gear radial clearance between the gear and input shaft.
0.009 to 0.050 mm (0.000355 to 0.00196 in.)
0.050 mm (0.00196 in.)
If the clearance exceeds the maximum, replace the 4th gear, 4th gear needle roller bearing or input shaft.
4.INSPECT 3RD GEAR RADIAL CLEARANCE
Using a dial indicator, measure the 3rd gear radial clearance.
0.015 to 0.058 mm (0.000591 to 0.00228 in.)
0.058 mm (0.00228 in.)
If the clearance exceeds the maximum, replace the 3rd gear, 3rd gear needle roller bearing or input shaft.
33334
5.REMOVE 4TH GEAR
Using 2 screwdrivers and a hammer, remove the input shaft rear bearing shaft snap ring from the input shaft.
Use a piece of cloth to keep the input shaft rear bearing shaft snap ring from flying off.
Using SST and a press, remove the input shaft rear radial ball bearing and the 4th gear from the input shaft.
Do not tighten SST excessively.
Support the input shaft by hand to prevent it from falling off.
33334A
6.REMOVE 4TH GEAR NEEDLE ROLLER BEARING
Remove the 4th gear needle roller bearing and the 4th gear bearing spacer from the input shaft.
33368H
7.REMOVE 4TH GEAR SYNCHRONIZER RING
Remove the 4th gear synchronizer ring from the No. 2 transmission clutch hub.
33333
8.REMOVE 3RD GEAR
Using 2 screwdrivers and a hammer, remove the No. 2 clutch hub setting shaft snap ring from the input shaft.
Use a piece of cloth to keep the No. 2 clutch hub setting shaft snap ring from flying off.
Using SST and a press, remove the No. 2 transmission clutch hub and the 3rd gear from the input shaft.
Do not tighten SST excessively.
Support the input shaft by hand to prevent it from falling off.
33368G
9.REMOVE 3RD GEAR SYNCHRONIZER RING
Remove the 3rd gear synchronizer ring from the 3rd gear.
33333A
10.REMOVE 3RD GEAR NEEDLE ROLLER BEARING
Remove the 3rd gear needle roller bearing from the input shaft.
33364
11.REMOVE NO. 2 TRANSMISSION HUB SLEEVE
Remove the No. 2 transmission hub sleeve, 3 synchromesh shifting keys and the 3 synchromesh shifting key springs from the No. 2 transmission clutch hub.
Use a piece of cloth to keep the synchromesh shifting keys and the synchromesh shifting key springs from flying off.