Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › SHIFT AND SELECT LEVER SHAFT(for 1NZ-FE) › 2013.08–2016.07
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0091176 SHIFT AND SELECT LEVER SHAFT(for 1NZ-FE) A

C50 MANUAL TRANSMISSION / TRANSAXLE  SHIFT AND SELECT LEVER SHAFT(for 1NZ-FE)  DISASSEMBLY  


PROCEDURE

Hide 33557F 1.REMOVE FLOOR SHIFT CONTROL BELLCRANK DUST COVER

a.
C264873

Remove the floor shift control bellcrank dust cover from the selecting bellcrank support.


Hide 33557A 2.REMOVE NO. 1 SELECTING BELLCRANK DUST COVER

a.
C264874

Remove the No. 1 selecting bellcrank dust cover from the selecting bellcrank support.


Hide 33534G 3.REMOVE NO. 2 SELECTING BELLCRANK PLATE WASHER

a.
C264875

Remove the nut and the selecting bellcrank plate washer from the No. 2 selecting bellcrank.


Hide 33534E 4.REMOVE NO. 2 SELECTING BELLCRANK

a.
C293457

Remove the No. 2 selecting bellcrank from the selecting bellcrank support.


Hide 33558 5.REMOVE NO. 2 SELECTING BELLCRANK DUST COVER

a.
C264877

Remove the No. 2 selecting bellcrank dust cover from the selecting bellcrank support.


Hide 33534F 6.REMOVE NO. 2 SELECTING BELLCRANK BUSH

a.
C155101

Remove the 2 No. 2 selecting bellcrank bushes from the selecting bellcrank support.


Hide 33520A 7.REMOVE FLOOR SHIFT CONTROL SHAFT ASSEMBLY

a.
C264878

Remove the nut and the floor shift control shaft assembly from the selecting bellcrank support.


Hide 33277 8.REMOVE NO. 2 SELECT SPRING SEAT

a.
C120733

Using a screwdriver, remove the E-ring, No. 2 select spring seat and the compression spring from the shift and select lever shaft.


Hide 33252A 9.REMOVE INNER NO. 2 SHIFT LEVER

a.
C120734

Using a 5 mm pin punch and a hammer, remove the inner No. 2 shift lever slotted spring pin and the inner No. 2 shift lever from the shift and select lever shaft.

HINT:

Check the orientation of the inner No. 2 shift lever.



Hide 33251A 10.REMOVE INNER NO. 1 SHIFT LEVER

a.
C286555

Using a pin 5 mm punch and a hammer, remove the inner No. 1 shift lever slotted spring pin, inner No. 1 shift lever and the shift interlock plate from the shift and select lever shaft.

HINT:

Check the orientation of the inner No. 1 shift lever.



Hide 33256 11.REMOVE SELECT INNER LEVER

a.
C120736

Using a 5 mm pin punch and a hammer, remove the select inner lever slotted spring pin, select inner lever, compression spring and the No. 1 select spring seat from the shift and select lever shaft.

HINT:

Check the orientation of the select inner lever.



Hide 33276H 12.REMOVE NO. 1 SELECT SPRING SEAT SHAFT SNAP RING

a.
C120737

Using 2 screwdrivers and a hammer, remove the No. 1 select spring seat shaft snap ring from the shift and select lever shaft.

HINT:

Use a piece of cloth to keep the No. 1 select spring seat shaft snap ring from flying off.