Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0091177 DIFFERENTIAL CASE G

C50 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  INSPECTION  


PROCEDURE

Hide 41351F 1.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER

a.
C283052

Using a micrometer, measure the thickness of the front differential pinion thrust washer.

Standard thickness:

0.94 to 1.06 mm (0.0371 to 0.0417 in.)


Minimum thickness:

0.94 mm (0.0371 in.)


If the thickness is less than the minimum, replace the front differential pinion thrust washer.


Hide 41342F 2.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.
C283053

Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.

Standard outer diameter:

16.982 to 17.000 mm (0.6686 to 0.6692 in.)


Minimum outer diameter:

16.982 mm (0.6686 in.)


If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.