Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091205 CAMSHAFT OIL CONTROL VALVE G

1NZ-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Check the resistance

i.
A171220C01
0.135,0.094 0.448,0.25 0.313,0.156 10 false *a
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.



b.

Check the operation

i.
A248873C01
1.01,1.469 1.292,0.865 true 0.073,0.063 0.385,0.219 0.313,0.156 10 false *a 0.688,0.99 1,1.146 0.313,0.156 10 false *b 0.542,1.979 0.854,2.135 0.313,0.156 10 false *c 1.333,0.771 1.646,0.927 0.313,0.156 10 false *d
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)
*b When Applied
*c When Cut Off
*d Spool Valve


Connect the positive (+) lead from a battery to terminal 1 and negative (-) lead to terminal 2, and check the movement of the camshaft timing oil control valve assembly.

OK:
Battery Connection Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Battery positive (+) voltage is applied Spool valve moves in direction of left arrow shown in illustration
Battery positive (+) voltage is cut off Spool valve moves in direction of right arrow shown in illustration


If the result is not as specified, replace the camshaft timing oil control valve assembly.

NOTICE:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.