Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › THROTTLE BODY › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091206 THROTTLE BODY G

1NZ-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the throttle control motor operating sounds.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check the operating sounds of the motor. Make sure that no friction noise is emitted from the motor.

If any friction noise exists, replace the throttle body with motor assembly.



b.

Check the throttle position sensor.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Position No. 1 and Throttle Position No. 2.

Powertrain > Engine and ECT > Data List
Tester Display
Throttle Position No.1
Throttle Position No.2
50003 234 282,283

v.

When the throttle valve is fully open, check that the Throttle Sensor Position value is within the specification.

Standard Throttle Valve Opening Percentage:
Tester Display Specified Condition
Throttle Sensor Position 60% or higher


CAUTION:

When checking the standard throttle valve opening percentage, the transaxle should be in neutral.


If the percentage is less than 60%, replace the throttle body with motor assembly.