Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › MASS AIR FLOW METER › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091209 MASS AIR FLOW METER G

1NZ-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Check the visual appearance

i.
A278924C07
1.083,0.813 1.51,0.385 1.51,0.385 1.125,0.969 true 1.573,0.229 1.885,0.427 0.313,0.198 10 *a
*a Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.



b.

Check the resistance

i.
A171219C01
2.094,0.99 2.573,0.438 true 1.906,0.99 1.448,0.438 true 0.125,0.094 0.438,0.25 0.313,0.156 10 false *a 2.635,0.354 3.156,0.583 0.521,0.229 10 false THA 1.229,0.344 1.75,0.573 0.521,0.229 10 false E2
*a Component without harness connected
(Mass Air Flow Meter)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


If the resistance is not as specified, replace the mass air flow meter.