11101E
1.INSTALL CAMSHAFT POSITION SENSOR
Apply a light coat of engine oil to the O-ring.
If reusing the camshaft position sensor, be sure to inspect the O-ring.
Install the camshaft position sensor to the cylinder head sub-assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the camshaft position sensor connector.
28800
2.INSTALL BATTERY
3.INSPECT FOR ENGINE OIL LEAK
11212
4.INSTALL NO. 2 CYLINDER HEAD COVER