Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2013.08–2016.07
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091211 CRANKSHAFT POSITION SENSOR A

1NZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51441C 1.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51451A 2.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 15100Q 4.REMOVE CRANKSHAFT POSITION SENSOR

a.
A182411

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the oil pump assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.