89465A
1.INSTALL HEATED OXYGEN SENSOR (for Sensor 2)
| *a | Fulcrum Length 30 mm |
| *b | Fulcrum Length 300 mm |
Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.
If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.
This torque value is effective when SST is parallel to the torque wrench.
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Pass the connector through the hole to the inside of the vehicle and install the grommet of the heated oxygen sensor.
Connect the heated oxygen sensor connector.
Return the front floor carpet assembly and engage it.
Install the clip to the front floor carpet assembly.
58910C
2.INSTALL REAR CONSOLE BOX ASSEMBLY
3.INSPECT FOR EXHAUST GAS LEAK