Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 2) › 2013.08–2014.03
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091216 HEATED OXYGEN SENSOR(for Sensor 2) G

1NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 2)  INSPECTION  


PROCEDURE

Hide 89465A 1.INSPECT HEATED OXYGEN SENSOR (for Sensor 2)

a.

Check the resistance.

i.
A171221C01
1.875,0.823 2.292,0.406 true 1.073,1.667 1.49,1.25 true 1.042,0.448 1.49,0.813 true 0.146,0.104 0.458,0.26 0.313,0.156 10 false *a 2.344,0.333 2.885,0.573 0.542,0.24 10 false HT1B 0.854,1.594 1.396,1.833 0.542,0.24 10 false E2 0.823,0.365 1.365,0.604 0.542,0.24 10 false +B
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.