22030
1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY
Check the throttle control motor operating sounds.
Turn the ignition switch to ON.
When depressing the accelerator pedal, check the operating sounds of the motor. Make sure that no friction noise is emitted from the motor.
If any friction noise exists, replace the throttle body with motor assembly.
Check the throttle position sensor.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Position No. 1 and Throttle Position No. 2.
| Tester Display |
|---|
| Throttle Position No.1 |
| Throttle Position No.2 |
When the throttle valve is fully open, check that the Throttle Sensor Position value is within the specification.
| Tester Display | Specified Condition |
|---|---|
| Throttle Sensor Position | 60% or higher |
When checking the standard throttle valve opening percentage, the transaxle should be in neutral.
If the percentage is less than 60%, replace the throttle body with motor assembly.