Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091221 ACCELERATOR PEDAL A

2NZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Install the accelerator pedal sensor assembly to the vehicle with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Do not disassemble the accelerator pedal sensor assembly.

·

If a component has been dropped or subjected to a strong impact, replace the accelerator pedal sensor assembly.

·

This accelerator pedal sensor assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.




b.

Connect the accelerator pedal sensor assembly connector.