Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › MASS AIR FLOW METER › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091222 MASS AIR FLOW METER G

2NZ-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the MAF value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed in the vehicle).

·

During the test, make sure that the exhaust air duct is not drawing air from the exhaust pipe.



a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.

NOTICE:

Do not run the engine.



c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

e.

Wait for 30 seconds, and read the values on the GTS.

Standard:
Tester Display Condition Standard Condition
MAF
·

Engine not running

·

30 seconds after ignition switch is turned to ON


0.24 g/sec or less


If the result is not as specified, replace the mass air flow meter.

If the result is within the specified range, inspect the mass air flow meter.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION