Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091223 CAMSHAFT POSITION SENSOR G

2NZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11101E 1.INSPECT CAMSHAFT POSITION SENSOR

a.

Check the resistance.

i.
A171223C01
0.125,0.094 0.438,0.25 0.313,0.156 10 false *a
*a Component without harness connected
(Camshaft Position Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Resistance
1 - 2 Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω


HINT:

In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F).


If the resistance is not as specified, replace the camshaft position sensor.