Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091223 CAMSHAFT POSITION SENSOR A

2NZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 11101E 3.REMOVE CAMSHAFT POSITION SENSOR

a.
A183419

Disconnect the camshaft position sensor connector.


b.
A183420

Remove the bolt and camshaft position sensor from the cylinder head sub-assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.