15100Q
1.INSTALL CRANKSHAFT POSITION SENSOR
Apply a light coat of engine oil to the O-ring.
If reusing the crankshaft position sensor, be sure to inspect the O-ring.
Install the crankshaft position sensor to the oil pump assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the crankshaft position sensor connector.
2.INSPECT FOR ENGINE OIL LEAK
51441C
3.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51405A
4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
5.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)