Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091224 CRANKSHAFT POSITION SENSOR G

2NZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 15100Q 1.INSPECT CRANKSHAFT POSITION SENSOR

a.

Check the resistance.

i.
A171224C01
0.156,0.115 0.469,0.271 0.313,0.156 10 false *a
*a Component without harness connected
(Crankshaft Position Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 985 to 1600 Ω
Hot 1265 to 1890 Ω


HINT:

In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F).


If the resistance is not as specified, replace the crankshaft position sensor.