Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 1) › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091228 HEATED OXYGEN SENSOR(for Sensor 1) G

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 1)  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR (for Sensor 1)

a.

Check the resistance.

i.
A171222C01
1.885,0.865 2.271,0.51 true 1.156,1.75 1.542,1.396 true 1.531,0.865 1.135,0.531 true 0.135,0.104 0.448,0.26 0.313,0.156 10 false *a 2.323,0.427 2.896,0.656 0.573,0.229 10 false HT1A 0.906,0.448 1.479,0.677 0.573,0.229 10 false +B 0.927,1.677 1.5,1.906 0.573,0.229 10 false E2
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1A) - 2 (+B) 20°C (68°F) 5.3 to 7.5 Ω
1 (HT1A) - 4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.