Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 1) › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091228 HEATED OXYGEN SENSOR(for Sensor 1) A

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 1)  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 2.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A268358

Disconnect the heated oxygen sensor connector.


b.

Disengage the 2 clamps to disconnect the heated oxygen sensor wire from the wire harness clamp bracket.


c.
A276995

Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.


d.

Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.


Hide 17167 3.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A179628

Remove the 3 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold.


Hide 89465 4.REMOVE HEATED OXYGEN SENSOR (for Sensor 1)

a.
A179641E01
0.708,0.604 1.135,1.448 true 0.406,0.521 0.865,0.719 0.458,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the exhaust manifold.

SST
09224-00010  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.