17111
1.INSTALL INTAKE MANIFOLD
Install a new intake manifold to head gasket to the intake manifold.
Temporarily install the intake manifold to the cylinder head sub-assembly with the 3 bolts and 2 nuts.
Tighten the 3 bolts and 2 nuts in the order shown in the illustration.
Install the 2 wire harness clamp brackets to the intake manifold with the 2 bolts.
Engage the clamp to connect the wire harness to the intake manifold.
Engage the 2 clamps to connect the wire harness to the wire harness clamp bracket.
15301
2.INSTALL OIL LEVEL DIPSTICK SUB-ASSEMBLY
Install the oil level dipstick sub-assembly to the oil level dipstick guide.
16553C
3.INSTALL HOSE CLAMP
Engage the clamp to install the hose clamp to the intake manifold.
4.INSTALL STUD BOLT
Using a "TORX" socket wrench E6, install the 3 stud bolts to the intake manifold.
44774
5.CONNECT UNION TO CONNECTOR TUBE HOSE
Connect the union to connector tube hose to the intake manifold with the hose clip.
12261
6.CONNECT VENTILATION HOSE
Connect the ventilation hose to the intake manifold with the hose clip.
16264
7.CONNECT NO. 2 WATER BY-PASS HOSE
Engage the clamp to connect the No. 2 water by-pass hose to the hose clamp.
22030
8.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY