Home › Engine / Hybrid System › 2NZ-FE INTAKE / EXHAUST › INTAKE MANIFOLD › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017080 2NZ-FE INTAKE / EXHAUST _0091235 INTAKE MANIFOLD A

2NZ-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 22030 1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 16264 2.DISCONNECT NO. 2 WATER BY-PASS HOSE

a.
A171145

Disengage the clamp to disconnect the No. 2 water by-pass hose from the hose clamp.


Hide 12261 3.DISCONNECT VENTILATION HOSE

a.
A171144

Loosen the hose clip and disconnect the ventilation hose from the intake manifold.


Hide 44774 4.DISCONNECT UNION TO CONNECTOR TUBE HOSE

a.
A171143

Loosen the hose clip and disconnect the union to connector tube hose from the intake manifold.


Hide 5.REMOVE STUD BOLT

a.
A171142

Using a "TORX" socket wrench E6, remove the 3 stud bolts from the intake manifold.


Hide 16553C 6.REMOVE HOSE CLAMP

a.
A171141

Disengage the clamp to remove the hose clamp from the intake manifold.


Hide 15301 7.REMOVE OIL LEVEL DIPSTICK SUB-ASSEMBLY

a.
A171140

Remove the oil level dipstick sub-assembly from the oil level dipstick guide.


Hide 17111 8.REMOVE INTAKE MANIFOLD

a.
A171139

Disengage the 2 clamps to disconnect the wire harness from the wire harness clamp bracket.


b.
A171138

Disengage the clamp to disconnect the wire harness from the intake manifold.


c.
A171137

Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.


d.
A171136

Remove the 2 nuts, 3 bolts and intake manifold from the cylinder head sub-assembly.


e.
A249596

Remove the intake manifold to head gasket from the intake manifold.