Home › Engine / Hybrid System › 2NZ-FE LUBRICATION › OIL PRESSURE SWITCH › 2013.08–2016.07
RM30M0E _51 Engine / Hybrid System _017084 2NZ-FE LUBRICATION _0091244 OIL PRESSURE SWITCH A

2NZ-FE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Clean and degrease the threads of the engine oil pressure switch assembly and threaded hole of the cylinder block sub-assembly.


b.
A105862C01
1.677,0.604 1.979,0.677 false 1.469,0.5 1.781,0.656 0.313,0.156 10 false *a
*a Adhesive


Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent


NOTICE:

To prevent contamination by foreign matter, install immediately after applying adhesive.



c.
A130345C01
1.583,0.948 1.948,1.396 true 1.917,1.417 2.083,1.604 0.167,0.188 10 true *a
*a 24 mm Deep Socket Wrench


Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the cylinder block sub-assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.



d.

Connect the engine oil pressure switch assembly connector.


Hide 51441C 3.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51442C 4.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 6.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)