Home › Engine / Hybrid System › 2NZ-FE LUBRICATION › OIL PUMP › 2013.08–2016.07
RM30M0E _51 Engine / Hybrid System _017084 2NZ-FE LUBRICATION _0091245 OIL PUMP G

2NZ-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

B344907

a.

Coat the oil pump relief valve with engine oil and check that it falls smoothly into the valve hole by its own weight.

If not, replace the oil pump relief valve. If necessary, replace the oil pump assembly.


Hide 2.INSPECT OIL PUMP ROTOR SET

A117456C01
2.646,1.594 2.885,2.563 true 0.927,0.854 1.823,0.333 true 1.833,0.198 2.01,0.365 0.177,0.167 10 false *a 2.781,2.573 2.958,2.74 0.177,0.167 10 false *a
*a Mark


a.

Install the oil pump rotor set with both of the marks facing the oil pump cover side.


b.
B344908

Check the rotor tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

Standard driven rotor tip clearance:

0.060 to 0.180 mm (0.0024 to 0.0071 in.)


Maximum driven rotor tip clearance:

0.28 mm (0.0110 in.)


If the tip clearance is greater than the maximum, replace the oil pump assembly.



c.
B344909

Check the rotor body clearance.

i.

Using a feeler gauge, measure the clearance between the driven rotor and oil pump body.

Standard oil pump body clearance:

0.250 to 0.325 mm (0.0098 to 0.0128 in.)


Maximum oil pump body clearance:

0.425 mm (0.0167 in.)


If the body clearance is greater than the maximum, replace the oil pump assembly.