The door control receiver is used to receive radio waves related to the entry functions of the electrical key transmitter sub-assembly. The certification ECU (smart key ECU assembly) decodes the requested electrical key transmitter sub-assembly operation by identifying a key code based on the radio waves received via the door control receiver. The door control receiver receives a signal from the electrical key transmitter sub-assembly and sends signals to the body computer through the certification ECU (smart key ECU assembly). (ex. if a door lock operation is requested, the certification ECU (smart key ECU assembly) sends a door lock command to the body computer).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1242 | Wireless Door Lock Tuner Circuit Malfunction | ·
Short in RDAS to ground between the certification ECU (smart key ECU assembly) and door control receiver. ·
Short in RDAS to ground when RCO (5 V) output from the ECU is off. |
·
Wire harness or connector ·
Door control receiver ·
Certification ECU (smart key ECU assembly) |
When replacing or inspecting the door control receiver and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control receiver, entry and wireless function performance may be affected.
This DTC is not detected within 10 seconds after the engine switch is turned to off from ON.
When replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
| *a | Front view of wire harness connector
(to Door control receiver) |
Disconnect the door control receiver connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F46-4 (+5) - F46-1 (GND) | Always | 4.5 to 5.5 V pulse generation at regular intervals |
| F46-5 (DATA) - F46-1 (GND) | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F46-1 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F46 door control receiver connector.
Disconnect the F43 and F44 certification ECU (smart key ECU assembly) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F46-5 (DATA) - F44-22 (RDAS) | Always | Below 1 Ω |
| F46-4 (+5) - F44-3 (RCO) | Always | Below 1 Ω |
| F43-10 (E) - Body ground | Always | Below 1 Ω |
| F46-5 (DATA) or F44-22 (RDAS) - Body ground | Always | 10 kΩ or higher |
| F46-4 (+5) or F44-3 (RCO) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG