Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM30M0E _58 Vehicle Interior _017115 SUPPLEMENTAL RESTRAINT SYSTEMS _0092014 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 45186 3.REMOVE NO. 2 STEERING WHEEL LOWER COVER

a.
B346971C01
1.135,0.74 1.448,0.333 true 1.469,0.219 1.781,0.417 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the No. 2 steering wheel lower cover.


Hide 45130 4.REMOVE HORN BUTTON ASSEMBLY

CAUTION:

When storing the horn button assembly, keep the airbag deployment side facing upward.


a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B346972C04
1.115,0.698 0.896,0.844 true 0.479,1.25 0.552,1.042 true 1.125,0.583 1.365,0.792 0.24,0.208 10 true *1 0.563,0.896 0.802,1.104 0.24,0.208 10 false *a
*1 Torsion Spring
*a TORX Driver


Using a "TORX" driver, push in the 3 torsion springs to disengage the 3 pins.

NOTICE:

Do not drop the horn button assembly.



d.

Pull out the horn button assembly from the steering wheel assembly and support the horn button assembly with one hand.

NOTICE:

When removing the horn button assembly, do not pull the airbag wire harness.



e.
B343553C01
0.729,2.594 1.146,2.594 true 0.573,2.771 0.99,2.771 true 1.188,2.51 1.5,2.667 0.313,0.156 10 false *a 1.063,2.698 1.375,2.854 0.313,0.156 10 false *1
*1 Locking Button
*a Protective Tape


Disconnect the horn connector.


f.

Using a screwdriver with its tip wrapped in protective tape, release the locking button.


g.

Disconnect the airbag connector to remove the horn button assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.