Always use E10 "TORX" socket wrench when removing the front seat assembly.
The procedure described below is for the LHD side. Use the same procedure for both the LHD and RHD side, unless otherwise specified.
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.
72138
1.REMOVE REAR OUTER SEAT TRACK BRACKET COVER
Move the front seat assembly to the foremost position.
Disengage the 4 claws to remove the rear outer seat track bracket cover.
2.REMOVE FRONT SEAT ASSEMBLY
Disconnect the buckle switch connector. (for Driver Side)
Using an E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the front seat assembly.
Move the front seat assembly to the rearmost position.
Using an E10 "TORX" socket wrench, remove the 2 bolts on the front side of the front seat assembly.
Lift up the vertical adjusting handle. (w/ Vertical Adjuster)
Remove the front seat assembly.
Be careful not to damage the vehicle body.