71077B
1.INSTALL BENCH TYPE REAR SEATBACK COVER
| *1 | Hog Ring |
| *a | Hog Ring Pliers |
Using hog ring pliers, install the bench type rear seatback cover to the bench type seatback pad with 34 new hog rings.
Be careful not to damage the bench type rear seatback cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
Align the center of the hog ring installation area of the bench type rear seatback cover with the center of the bench type rear seatback pad so that no wrinkles appear, and securely tighten the hog rings as shown in the illustration.
2.INSTALL REAR SEAT HEADREST SUPPORT ASSEMBLY
| *a | Protruding |
w/ Rear Center Seat Headrest:
Align the protruding portion of the rear seat headrest support assembly with the installation groove of the bench type rear seatback pad.
Engage the 12 claws to install the 6 rear seat headrest support assemblies.
| *a | Protruding |
w/o Rear Center Seat Headrest:
Align the protruding portion of the rear seat headrest support assembly with the installation groove of the bench type rear seatback pad.
Engage the 8 claws to install the 4 rear seat headrest support assemblies.
73344
3.INSTALL REAR SEAT SHOULDER BELT GUIDE LH
Use the same procedure for both sides. (for 3 Point Type Rear Center Seat Belt)
Engage the guide to install the rear seat shoulder belt guide LH.
Install the 2 screws.
73343
4.INSTALL REAR SEAT SHOULDER BELT GUIDE RH
Engage the guide to install the rear seat shoulder belt guide RH.
Install the 2 screws.
71075B
5.INSTALL BENCH TYPE REAR SEAT CUSHION COVER
| *1 | Hog Ring |
| *a | Hog Ring Pliers |
Using hog ring pliers, install the bench type rear seat cushion cover to the bench type rear seat cushion pad with 44 new hog rings.
Be careful not to damage the bench type rear seat cushion cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
Align the center of the hog ring installation area of the bench type rear seat cushion cover with the center of the bench type rear seat cushion pad so that no wrinkles appear, and securely tighten the hog rings as shown in the illustration.
71960B
6.INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (w/ Rear Center Seat Headrest)
Install the rear seat center headrest assembly.
71940A
7.INSTALL REAR SEAT HEADREST ASSEMBLY
Install the 2 rear seat headrest assemblies.