23250
1.INSPECT FUEL INJECTOR ASSEMBLY
| *a | Component without harness connected
(Fuel Injector Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 25°C (77°F) | 11.8 to 12.6 Ω |
If the result is not as specified, replace the fuel injector assembly.
Inspect the injector injection volume.
Keep the fuel injector assembly away from sparks during the test.
| *1 | Fuel Pipe (Vehicle Side) |
| *a | SST (Hose) |
| *b | SST (Hose Band) |
| *c | SST (Fuel Tube Connector) |
Connect SST (fuel tube connector) to SST (hose), and then connect them to the fuel pipe (vehicle side).
| *1 | O-Ring |
| *a | SST (Hose) |
| *b | SST (Hose Band) |
| *c | SST (Adapter) |
| *d | SST (Clamp) |
| *e | Vinyl Tube |
Install a new O-ring to the fuel injector assembly.
Connect SST (adapter and hose) to the fuel injector assembly, and hold the fuel injector assembly and union with SST (clamp).
Install a vinyl tube to the fuel injector assembly.
Install a suitable vinyl tube to the fuel injector assembly to contain any gasoline spray.
| *a | SST (Tie Band) |
| *b | SST (Adapter) |
| *c | SST (Clamp) |
Tie SST (clamp) and SST (adapter) together with SST (tie band) as shown in the illustration.
Put the fuel injector assembly to a graduated cylinder.
Install a suitable vinyl tube to the fuel injector assembly to prevent gasoline splashes.
Operate the fuel pump (for Automatic Transaxle).
Operate the fuel pump (for Manual Transaxle).
| *a | SST (Wire) |
| *b | Connect |
Connect SST (wire) to the fuel injector assembly and battery for 15 seconds, and measure the injector injection volume with the graduated cylinder. Test each fuel injector assembly 2 or 3 times.
Always switch the voltage on and off at the battery side, not the fuel injector assembly side.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Positive terminal - Ground terminal | Per 15 seconds | 47 to 58 cm3 (2.9 to 3.5 cu in.) |
11 cm3 (0.7 cu in.) or less
If the result is not as specified, replace the fuel injector assembly.
Inspect for leaks.
In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel drop from the fuel injector assembly.
1 drop or less every 12 minutes
If fuel drop is not as specified, replace the fuel injector assembly.