83320
1.INSPECT FUEL SENDER GAUGE ASSEMBLY
Check that the float moves smoothly between F (Upper End) and E (Lower End).
| *a | Component without harness connected
(Fuel Sender Gauge Assembly) |
| *b | F (Upper End) |
| *c | E (Lower End) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | F (Upper End) | 13.5 to 16.5 Ω |
| Between F (Upper End) - E (Lower End) | 13.5 to 414.5 Ω
(Gradually Changes) |
|
| E (Lower End) | 405.5 to 414.5 Ω |
If the result is not as specified, replace the fuel sender gauge assembly.